







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
What Concrete Driveways & Concrete Work in Richardson actually involves
Concrete driveway installation in Richardson runs $4,500 – $12,000, and a full replacement sits at $5,000 – $14,000 depending on size, demo, and how much of the existing slab has to come out. Most Richardson driveways we pour take 3 to 5 days from demo to the first walk-on, then 7 days before you park on the surface. Call (844) 560-0925 and we’ll set up a free on-site estimate.

How we do this job, stage by stage

Concrete work rewards patience and punishes shortcuts. A driveway that cracks in two years was usually poured wet, poured thin, or poured over a base that was never compacted. Here’s the sequence we actually run on a Richardson job.
1. Site walk and layout (day 1, about an hour)
We measure the existing slab, mark the pour, and check the slope away from the garage and the house. You’ll decide the finish, the width (12 ft vs 16 ft vs a wider pull-through), and whether you want an apron tied into the street or a separate expansion joint at the sidewalk. This is also where we note anything buried: irrigation lines, the gas stub, old cast-iron from a previous build-out.
2. Demo and haul-off (day 1 – 2)
If there’s an old driveway or a crumbling approach apron, we break it out with a jackhammer or a mini-skid and haul the concrete off. A 400 to 600 square foot single-car slab usually comes out in under a day. A wider two-car drive with a deep footing at the garage lip can run into day two. You’ll know the demo date before we start.
3. Subgrade prep and form-up (day 2 – 3)
This is where Richardson’s clay matters most. We excavate 6 to 8 inches, compact the subgrade, and set forms. On expansive blackland clay we spec a 4 to 6 inch compacted flexible base plus rebar at 18 to 24 inch centers instead of the minimum wire mesh, because North Texas soil movement will find any thin spot. We check the forms for grade and drainage before anything else happens.
4. Pour and finish (day 3 – 4)
We place the concrete, screed it, and float it. You’ll pick the finish at the estimate stage: broom (the default for traction in rain), a light salt or exposed-aggregate finish, or saw-cut control joints laid out at roughly 8 to 12 foot spacing to direct cracks where you want them. Control joints are not optional here. We pour early in the morning during a Richardson summer so the mix doesn’t flash-set at 100°F.
5. Cure and walk-on (days 4 – 11)
The slab needs 7 days of cure before you drive a car on it, and longer if the homeowner wants a sealer applied. We keep traffic off, keep water on it in hot weather, and return for a final walk to check joints and edges. If the job is part of a full Driveway & Pavers in Richardson project, we coordinate the phase so the concrete cures while other work is moving.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between
- Broom-finish gray concrete: the standard, and for good reason. Grippy when wet, low maintenance, and the cheapest finish at the low end of the $4,500 – $12,000 range. It’s what most Richardson homes were originally poured with.
- Exposed aggregate or salt finish: rough texture and more visual interest. Costs more and hides stains better than flat gray, but the texture is harder to shovel in winter weather and can trap dirt in shaded areas.
- Reinforcement: wire mesh is the cheap baseline; rebar grid is what we recommend for any driveway over 400 sq ft on this soil. The rebar adds cost but is the single biggest factor in whether the slab stays tight for 20 years or cracks across a control joint.
- Thickness: 4 inches is thin and will fail under a heavy pickup. 5 to 6 inches with a thickened edge at the garage lip is the practical spec, and thicker means more concrete and higher cost.
- Sealer: a penetrating sealer every few years keeps water out of hairline cracks. Optional, and it’s a small add-on, but it pays off on slab durability.
What Concrete Driveways & Concrete Work costs in Richardson, TX
For Richardson, concrete driveway installation runs $4,500 – $12,000, and replacement (demo of the old slab plus a new pour) runs $5,000 – $14,000. A small apron or a side flare is at the low end; a wide two-car drive with demo, rebar, and a finish upgrade is at the high end. Four things move the number:
- Square footage and thickness: a 300 sq ft single apron and a 700 sq ft two-car drive aren’t the same job, and going from 4 to 6 inches adds concrete and labor.
- Demo and haul-off: old concrete has to be broken out and trucked away, and that’s a real line item if there’s a slab to remove.
- Subgrade condition: soft spots, root removal, or a failed base means more excavation before the pour.
- Reinforcement and finish: rebar versus mesh, and broom versus exposed aggregate, are both priced choices that move the total.
Every written estimate is a line-item quote: demo, haul, base, steel, concrete, finish, joints, and cleanup, each with a number. What’s not included unless it’s on the quote: driveway widening that requires a new curb cut or city right-of-way work, drainage corrections, and any structural work if the pour ties into a garage that needs repair. Call (844) 560-0925 to get your line items priced.

See the difference
Before
After
Before
After
Before
AfterWhat Richardson homes specifically do to this job
Richardson’s identity is tied to its Telecom Corridor legacy and mid-century master-planned growth. The 75080 and 75081 ZIPs were built out largely in the 1950s – 70s around Collins Radio and Texas Instruments, so a contractor pouring concrete here spends most days on renovation work, not raw land. Those original driveways are often 50 to 70 years old, poured thin, and cracked across the middle because they sit on the same expansive blackland and caliche clay that moves the slab foundations across the west side. A 1965 ranch off the Arapaho corridor typically needs the full demolition, not a patch. The 75082 ZIP, east of Central Expressway around the Campbell Road corridor, is newer 1980s – 2000s construction where we more often pour new or wider drives without the deep rehab. Tear-down rebuilds beside original ranchers are routine here, and on those lots survey and drainage review is part of the job before we pour. If you’re planning a broader exterior scope, our Driveway & Pavers service handles the pavers and patios alongside the concrete.
Serving Richardson, TX – Our Local Coverage Area
We serve Richardson and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Concrete Driveways & Concrete Work in Richardson

Most Richardson jobs run 3 to 5 working days from demo to finish, then 7 days of cure before you drive on it. Weather windows matter here, so we plan around the spring storm pattern and pour early in the summer heat. Call (844) 560-0925 to get your date on the calendar.
Most residential driveway replacements don’t need a separate building permit, but any change to the curb cut or public right-of-way usually does. We handle the permit question during the estimate and pull what’s required before the first load of concrete arrives. Call (844) 560-0925 and we’ll tell you what applies to your lot.
Sometimes, but only if the existing slab is sound and the subgrade holds up. A 50-year-old cracked slab on clay usually can’t be overlaid safely, and the honest answer on those Richardson jobs is replacement. We’ll inspect the base and give you a straight recommendation instead of a patch that fails next year.
Concrete driveway installation here runs $4,500 – $12,000, and full replacement with demo runs $5,000 – $14,000. Width, thickness, rebar, finish, and subgrade condition all move the price. Call (844) 560-0925 for a free written line-item estimate.
Our workmanship is backed by the 730-Day Done Right Promise: if it isn’t done right, we make it right. That covers our pour, formwork, and finish, not damage from later digging or structural shifts. Call (844) 560-0925 to review warranty details before the pour.
Homeowners often pair this with ADU Site Prep & Utilities in Richardson when they’re adding a garage conversion or back unit, and with Door Installation in Richardson if the new approach changes the garage or entry. You’re covered across Richardson and the surrounding ZIPs.
Get a free estimate for Concrete Driveways & Concrete Work in Richardson
Call (844) 560-0925 for a free on-site estimate on your concrete drive. We’ll measure the existing slab, check the subgrade, and hand you a written line-item price with no-hassle upfront pricing, so the number you see is the number you pay. A live person answers the phone any hour, and we can review 0% financing for 18 months and $1,000 off projects over $10,000 on your call.
Written by the team at Groundwork Construction Co.












