







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Murphy, TX: What It Takes and What It Costs
Door Installation in Murphy, TX usually runs $1,200 to $6,500 for a single exterior door, with most entry-door replacements landing between $2,000 and $4,000. A basic swap takes one day; a door that needs a widened rough opening, new framing, or a reinforced wind-rated jamb set can stretch to three. Call (844) 560-0925 and we’ll walk your opening and give you a written, line-item number before anything gets ordered.

How we run a door installation from first measurement to final swing

Doors aren’t a “show up and hang it” job. The order we work in is what keeps a Murphy door from leaking, sticking, or rattling in the first north wind.
Stage 1: Measure and assess the opening (day 1, about an hour)
We pull the actual dimensions of the rough opening, check the header for sag, and look at the framing behind the trim. On Murphy’s brick-veneer homes this is where we find out whether the existing jamb is bedded into the brick or set inside a wood buck. That single fact decides whether we’re doing a straight replacement or a full frame-and-flash rebuild. You decide the door style and swing here, not later.
Stage 2: Order and confirm (roughly 2 to 5 weeks depending on spec)
Stock sizes in a standard material move fastest. A custom width, a specific glass package, or an impact-rated unit built to your wind zone adds lead time. We confirm the exact unit, hardware, and finish in writing before it ships, so there’s no surprise at the door when it arrives.
Stage 3: Demo and prep (day of install, 1 to 2 hours)
Old door and trim come out, the opening gets cleaned back to solid framing, and any rotten sill or threshold material gets cut out and replaced. We check the rough opening for square and plumb before a new unit ever goes in. If the framing is out, we fix it now, not after the door is hung.
Stage 4: Set, flash, and seal (the bulk of the day)
The new unit gets shimmed, plumbed, and fastened, then flashed at the head and sill and sealed at the perimeter. On our exterior installs the flashing detail is the part that actually keeps water out of your wall, so it gets done right the first time. Hardware, lockset, and closer go on last. This is the stage that takes the longest and the one you don’t want rushed.
Stage 5: Inspect and hand off
We check the swing, the latch, and the weather seal, then walk it with you. If the job pulled a permit, we schedule the inspection and meet the inspector on site. Most standard replacements finish in a single day; framed rebuilds run two to three.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll actually choose between
Most of the decisions on a Murphy door come down to four or five real trade-offs. Here’s how we frame them so the choice is yours, not ours.
- Steel vs. fiberglass vs. wood exterior. Steel is the budget-friendly, dent-prone workhorse that holds paint well. Fiberglass resists dents and moisture and is the sweet spot for our climate. Solid wood looks best and costs the most, and it needs re-finishing every few years against North Texas sun and humidity.
- Wind-rated vs. standard. A wind-rated or impact-rated door and reinforced jamb set costs more up front, but it’s what holds up when a spring storm rolls through. Standard units can be fine, but the frame and hardware are what fail first in high wind, not the slab.
- Pre-hung vs. slab. A pre-hung unit comes with frame and is faster to set and easier to seal. A slab keeps your existing frame and costs less, but only works if the frame is still sound and square. On older Murphy homes we frequently find the frame is the problem, not the door.
- Hardware and finish. Standard builder-grade locksets versus a reinforced, higher-security set. This is a small line on the estimate and a big difference in how the door feels and how secure it is.
We work with established manufacturers like Andersen and Marvin on door and glazing packages where the spec calls for them, and we’ll tell you plainly when a stock unit does the job just as well.
What Door Installation costs in Murphy, TX
Here’s the honest range, so you can budget before anyone knocks on your door:
- Standard exterior door replacement: $1,200 – $3,500
- Entry door with sidelites or upgraded glass: $2,500 – $5,500
- Wind-rated / impact-rated exterior door: $3,000 – $6,500
- Interior door replacement (per door): $300 – $900
- Frame rebuild or rough-opening modification: $800 – $2,500 added
What pushes a job toward the high end: an oversized or custom-width opening, a frame that’s rotted or out of square, moving the door to a new location in the wall, a material upgrade to solid wood or impact glass, and any permit scope that requires inspection. A straight stock swap on a sound frame sits near the bottom.

Your written estimate spells out the unit, hardware, flashing, sealant, disposal of the old door, and any framing repair we can see. It won’t include hidden rot we can’t find until demo, but we flag that risk in writing before we start so there’s no surprise later. The number you see is the number you pay, backed by our 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat Murphy homes specifically do to this job
Murphy is a built-out Collin County suburb, and that shapes every door install here. Nearly all the homes we work on went up between the 1980s and 2000s, so we’re almost always in an occupied house on a tight, fully developed lot, not on open land. Crews, materials, and the old door have to fit on a narrow driveway with no vacant lot next door to stage on. Working in established neighborhoods like the streets off FM 544 and near Murphy Road means planning the truck and dumpster placement as carefully as the install itself.
The local climate adds its own reality. Hail and high-wind events are a recurring concern in this part of North Texas, which is exactly why we push wind-rated doors and reinforced jambs rather than treating them as an upsell. The blackland clay under most Murphy slabs swells and shrinks with the wet-dry cycle, so an out-of-square opening is often a foundation-movement story, not a door story. We check for that before we order anything.
If the door work turns into a bigger exterior project, it’s often part of a full Windows & Doors in Murphy update, and homeowners frequently pair a new entry with Cabinets & Countertops in Murphy when they’re refreshing the entry-adjacent spaces at the same time. You can see the full range of what we handle on our Windows & Doors service page, and we cover the whole of Murphy for this kind of work.
Serving Murphy, TX – Our Local Coverage Area
We serve Murphy and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Door Installation in Murphy

A standard exterior door replacement takes one day, start to finish. Custom-width units, framed rebuilds, or jobs that pull a permit and need inspection can run two to three days. Call (844) 560-0925 and we’ll give you a realistic window for your specific door.
Like-for-like replacements usually don’t require a permit, while structural changes, new openings, or wind-rated upgrades that change the opening often do. We check the local requirement for your address and pull the permit if it’s needed, and we meet the inspector on site. Call (844) 560-0925 to confirm what your job calls for.
Yes, in most cases. A replacement into the existing opening doesn’t touch structure, plumbing, or wiring. Relocating a door or widening the opening is a different job with framing and possible header work, and we’ll tell you which one you’re looking at before quoting. Call (844) 560-0925 for a straight answer.
Wind-rated doors and reinforced jambs hold up better when high-wind storms hit North Texas. The frame and hardware fail before the slab does, so reinforcement is what actually protects the opening. We’ll show you where the upgrade is worth it and where a standard unit is fine. Call (844) 560-0925 to talk it through.
Every door we install is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That’s on top of the manufacturer’s warranty on the door itself. Call (844) 560-0925 with your model and we’ll explain exactly what’s covered.
Get a free estimate for Door Installation in Murphy
Call (844) 560-0925 for a free on-site estimate on your door installation in Murphy. A live person answers around the clock, we measure your opening, and you get a written, line-item quote before a single thing is ordered. Financing at 0% for 18 months is available, and projects over $10,000 take $1,000 off. Whether it’s a storm-ready entry door or a set of interior doors in a Garage Conversion ADU in Murphy, we’ll give you the number and stand behind it.
Written by the team at Groundwork Construction Co.












