







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
The short answer: a new concrete driveway in University Park typically runs $4,500 to $12,000 for a full installation, and most residential pours are finished in three to five working days once we start. Replacement, where we tear out and haul off the old slab first, lands closer to $5,000 to $14,000. For an exact number on your lot, call (844) 560-0925 and we’ll schedule a free on-site estimate.

Concrete work around here is rarely a clean-slate job. Driveway pours in University Park are squeezed between occupied homes on 50- and 60-foot-wide lots, and the slab has to outlast blackland clay that swells and shrinks with every wet and dry cycle. We build for that reality, not for an open field.
How Concrete Driveways & Concrete Work actually goes, start to finish
A driveway pour looks simple from the street. It isn’t. Here’s the real sequence we follow in University Park, and what you’ll be deciding at each stage.
Stage 1: Site check and the layout decision (1 to 2 hours, before we quote)
We walk the driveway footprint, check the slope away from the garage, and look at what’s underneath – existing slab thickness, tree roots, old utility trenches. On tight University Park lots, this is also where we measure your usable width against the side-yard setbacks and confirm where the concrete can sit and where the truck can actually back in. You decide the driveway width and the apron line at the street during this visit.
Stage 2: Demo, haul-off, and subgrade prep (Day 1 into Day 2)
For a replacement, the old slab comes out with a skid-steer and goes into a dumpster staged on the street under a town-approved placement. That’s not optional here – with zero-lot-line-style side yards, there’s no room on the property for a container. We then grade the subgrade, compact it in lifts, and check the moisture in the clay so the base doesn’t pump when it loads. You’ll want to move vehicles and clear access before this day, because the driveway is gone once demo starts.
Stage 3: Formwork and reinforcement (half a day to a full day)
We set the forms to the finished grade, tie the rebar grid, and set control-joint locations. On a typical University Park driveway we run #3 or #4 rebar at 16 to 24 inches on center over a 4-inch compacted base, and the slab itself at 4 to 6 inches depending on whether heavier vehicles will park on it. Expansion joints go against the garage slab, the apron, and any adjacent structure. You decide here whether you want a decorative finish (more on that below) and where the joints land.
Stage 4: Pour, screed, and finish (Day 3, morning pour)
Concrete arrives by truck and gets placed, screeded, and floated. This is the day the job either looks clean or doesn’t, and weather controls the schedule – North Texas summer heat forces us to pour early and finish fast to avoid plastic shrinkage cracks. The finish (broom, salt, exposed aggregate, saw-cut decorative) is applied wet. You don’t need to be there, but this is the moment to confirm the finish pattern if you haven’t already.
Stage 5: Cure and joint sealing (Days 3 to 7, then a follow-up)
Concrete keeps gaining strength for weeks, but the slab is usually fine for foot traffic in 24 hours and drivable in about 7 days. We keep vehicles off it until then and return after full cure to seal the joints and check for any early cracking. If anything needs attention inside the 730-Day Done Right Promise window, we come back and make it right.
The choices that shape your concrete in University Park
Most of the “how much” conversation comes down to a handful of decisions. Here’s what we walk through with homeowners:
- Plain broom finish vs. decorative: A standard broom finish is the workhorse – it grips well under wet feet and keeps cost down. Stamped or exposed-aggregate finishes add visual interest but cost more and need more careful maintenance, especially under our sun.
- 4-inch vs. 6-inch slab: 4 inches is fine for a standard car; go to 6 inches with heavier reinforcement if a truck or trailer regularly sits on it, and you’ll trade a little cost for a longer life over the clay.
- Rebar vs. mesh: We default to rebar on driveways here. The blackland clay flexes, and a steel grid handles that better than wire mesh.
- Drainage approach: Positive slope away from the garage is a given; what you choose is whether you want a channel drain or a simple swale at the apron. On tight lots, water runs toward a neighbor fast.
- Width: A single-car width saves concrete; a two-car width is more forgiving to back out of and park on. The footprint decision is also a lot-coverage decision here, so plan it early.
- Brand and supplier: Ready-mix is ready-mix, but specifying a consistent mix design with a known supplier (the way we’d specify Cover or Dvele when a build calls for a modular or panel system elsewhere on the lot) keeps the pour predictable.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
What Concrete Driveways & Concrete Work costs in University Park, TX
Plan on $4,500 to $12,000 for a new concrete driveway installation, and $5,000 to $14,000 for a full replacement where we demo and haul off the old slab. What pushes a job toward the top of that range:

- Size. Driveway length and width drive the concrete volume, and every extra square foot hits both material and labor.
- Existing condition. Old slab thickness, buried obstructions, old utility lines, and tree roots all add demo and prep time.
- Access and staging. Narrow University Park side yards mean more coordination, dumpster placement on the street, and careful truck positioning – real labor that’s invisible on a small lot.
- Grade and drainage work. Regrading to get water away from the garage or adding a channel drain adds cost.
- Finish and reinforcement. Decorative finishes and heavier reinforcement are upgrade lines, not base.
A written, line-item estimate from us shows the concrete volume, base prep, reinforcement, finish, and disposal separately, so you can see exactly what you’re paying for. Upfront pricing, no surprises – the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhy University Park specifically changes this job

University Park is a built-out, landlocked Park Cities enclave where the only way to build is tear-down and rebuild, so nearly every concrete job here is really a lot-coverage, setback, and height-limit exercise under tight municipal review and HPARC oversight – not greenfield work. Contractors working in the 75225 ZIP are essentially squeezing new pours onto 50- and 60-foot-wide lots next to occupied million-dollar houses. That changes everything: the slab footprint has to satisfy lot-coverage limits, dumpsters and concrete trucks stage on the street because there’s nowhere else to put them, and we coordinate that with the town before the first wheelbarrow rolls.
The soil underneath is the other factor. Our blackland clay expands and contracts through wet-dry cycles, and driveways that skip proper subgrade prep and reinforcement heave and crack a few seasons in. We see it most on older brick bungalow and Tudor cottage properties where a thin original slab has been patched a dozen times. If the driveway is part of a full Driveway & Pavers in University Park project, we plan the concrete and the surrounding hardscape together so the joints line up and water drains one direction.
Serving University Park, TX – Our Local Coverage Area
We serve University Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Concrete Driveways & Concrete Work in University Park
Most jobs finish in three to five working days, with the slab drivable in about a week after the pour. Demo and prep take a day or two, the pour itself is usually a single morning, and cure time runs the rest. Weather can stretch the schedule in North Texas, especially summer heat and spring storms. Call (844) 560-0925 for a realistic timeline on your lot – estimates are free.
For a standard driveway replacement or addition, yes – town review is part of life here, and lot-coverage and setback limits are checked during that review. We handle the permit coordination and inspections as part of the job. Call (844) 560-0925 and we’ll walk you through what your project needs.
Usually, but it depends on what’s buried. Old utility lines, sprinkler systems, and tree roots can force a reroute. We check the subgrade during the site visit so we know before we quote, not after. Call (844) 560-0925 to schedule the estimate.
A new installation runs $4,500 to $12,000, and a replacement runs $5,000 to $14,000, depending on size, access, and finish. Call (844) 560-0925 for an exact quote.
Every project is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. That’s in writing, not implied. Call (844) 560-0925 to get your estimate started.
Get your concrete estimated in University Park

If the driveway’s cracking, heaving, or you’re pouring new on a tear-down lot, start with a free on-site estimate. We’ll walk the footprint with you, check the subgrade and drainage, and hand you a line-item written quote – no obligation. Call (844) 560-0925, and a live person picks up. University Park homeowners often pair this with ADU Site Prep & Utilities in University Park or Door Installation in University Park; our Driveway & Pavers team covers the wider scope across University Park.
Written by the team at Groundwork Construction Co. of Carrollton.












