







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Prosper, TX: What It Costs and How Fast It Goes Up
A chain link fence in Prosper, TX runs $3,500 – $9,000 for most residential lots, with typical backyards landing around $4,200 – $6,500. Most jobs are surveyed and set within two to three working days, on site for one to two of them. Call (844) 560-0925 and we’ll walk your lot, check the setback lines and HOA paperwork, and hand you a written line-item quote before anyone touches a post-hole digger.

How We Build a Chain Link Fence in Prosper, Start to Finish

Chain link is a fast job done right and a slow job done wrong. The difference sits almost entirely in the first day: layout, soil, and the depth of the concrete footings. Here’s the actual sequence.
Day 1 morning: stake-out and locate
We meet you on the lot and walk the property line with the stakes and string out. This is where you approve the exact layout and gate placement, and where we call in the Texas 811 locate request so utility lines are marked before a digging bar goes in the ground. On a Prosper lot, that locate call matters more than people expect, since newer subdivision phases often carry irrigation and fiber runs close to the fence line. Add two to three business days from the locate call to work starting.
Day 1 afternoon: posts set
Terminal posts, corner posts, and gate posts get set in concrete, and everything else gets marked for the next day. On Blackland Prairie clay, that means deeper footings and more concrete per post than the generic minimum, because clay that swells and shrinks will lever a shallow post straight out over a couple of wet-dry cycles. Slab and pier work follow the same clay. If you’re also pouring flatwork, homeowners often pair this with ADU Site Prep & Utilities in Prosper, and the footing logic is identical.
Day 1 late: concrete cure window
You’ll notice the fence goes quiet while the footings cure. This is normal. We’re back the next working day, and the delay is what keeps your posts dead vertical for a couple of decades instead of a couple of seasons. Nobody short-cuts their way to a straight fence.
Day 2: rails, mesh, gate
Top rail, tension bands, fabric, tie wires, and the gate get hung and adjusted. Fabric gets tensioned with a come-along rather than hand-pulled so it doesn’t sag between posts by month three. Gate hardware gets checked for swing, latch alignment, and hold-open angle, then we walk the whole run with you. You approve the finished line before we pack up.
Day 2 close: cleanup and walkthrough
We haul off the spoil, sweep the fence line, and leave you with the warranty paperwork and the gate swing set the way you’ll actually use it. That includes any discussion of where a driveway gate arm or privacy slats would go later if you change your mind.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Chain Link Fence Options That Move Your Total
Chain link is a family of options, not one product. Here’s what you actually pick between, and the honest trade-off of each.
- Gauge of the mesh. The two standard residential grades are 11.5-gauge and 9-gauge wire. Thinner wire saves money up front and shows dents from a thrown ball or a coyote hitting the run; heavier wire costs more and shrugs off the same abuse. For a back fence shielding a dog run or a pool, we lean heavy.
- Fabric height. 4 feet for marking a side yard, 5 feet for the typical backyard, 6 feet or taller where you want a real barrier and a bit more visual screening. Each step up adds mesh cost and sometimes post size.
- Coating. Galvanized steel is the budget standard and holds up fine in North Texas dryness. Vinyl-coated mesh (black or green) costs more, hides rust bloom on scratch points, and reads less industrial from the neighbor’s side. On a new-build lot where the fence line is visible from the street, black vinyl-coated is the popular pick.
- Post size and wall thickness. 2 3/8-inch line posts are common; 2 7/8-inch posts and heavier wall thickness are what you want on a long run or a tall gate that sees daily use.
- Gates. Walk gates and drive gates both swing or slide. A sliding drive gate costs more and needs solid ground and a top track; a swing drive gate needs robust hinge posts and a brace, because that’s where a cheap chain link fence fails first.
- Top rail. Standard 1 5/8-inch top rail is fine at 5 feet. Shorter post spacing and a heavier top rail keep long runs from waving.
If the run connects to hardscape or a driveway crossing, put a concrete collar or sleeve in at that point. If you’re also replacing the entry door on the house, homeowners often pair this with Door Installation in Prosper, and the same walkthrough can cover both.
What a Chain Link Fence Costs in Prosper, TX
The range for this job is $3,500 – $9,000. Most residential backyards in 75078 finish between $4,200 and $6,500, and the high end is where gates, height, and difficult ground show up.

Here’s what actually pushes a quote toward the low or high end:
- Linear footage. A simple 120-foot back line with a walk gate sits down in the $3,500 – $4,500 band. A wraparound lot line with side yards runs past 250 feet and lands near the top.
- Gates. A walk gate adds roughly $250 – $600. A drive gate adds $700 – $1,800 or more depending on width and swing versus slide, and its post and footing work is the heaviest part of any chain link job.
- Mesh gauge and coating. Upgrading from thin galvanized to heavy 9-gauge vinyl-coated mesh can add 20% – 35% to material cost.
- Site conditions. Rock in the trench, a need to pull stumps or grade along the line, or an existing fence to tear out and haul away all add labor.
- Permit and inspection. Where a fence height or corner-lot setback triggers a permit, add the fee and a couple of days.
What’s in a written estimate from us: posts, footings and concrete, top rail, mesh, tension bands, tie wires, gates and their hardware, tear-out of an old fence if needed, haul-away, and the 730-Day Done Right Promise on workmanship. What’s typically not: utility locate fees where an HOA or municipality passes them through, landscape repair outside the work zone, and any fence that requires a survey we don’t already have.
See the difference
Before
After
Before
After
Before
AfterWhat Prosper Homes Specifically Do to This Job
Prosper is one of the fastest-growing exurban boomtowns in North Texas, and the fence work here follows the growth. Rather than repairing old fences on settled lots, most chain link jobs we quote are on lots that were pasture a few years back, in newly platted phases of master-planned subdivisions. That changes the real coordination problem: you’re working around active phases, builder traffic, and phase-in schedules rather than an aging fence line. HOA design review is common in these subdivisions, and most require submittal and approval before a fence goes up. Height, color, and material are usually spelled out, so plan on two to three weeks for review on a new build. Where the fence is a boundary line between two lots, the setback from the property line matters and is worth confirming against your plat before we stake out.
The clay underneath is the other story. Expansive Blackland Prairie soil swells in wet spring and shrinks hard in a dry summer, and that same movement is why post-tension slabs and careful piering are standard on new Prosper homes just a few years old. For a fence, the answer is straightforward: deeper footings, more concrete, and a firm berth in that clay rather than a surface set. We see the same failure mode on fences others built here. Shallow posts pop within a season or two, and gates go out of plumb.
Serving Prosper, TX – Our Local Coverage Area
We serve Prosper and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Chain Link Fence in Prosper

The chain link fence itself is usually on site for one or two working days. Add the 811 locate window and the concrete cure between posts and mesh. From first walkthrough to finished gate, plan on about three or four working days, more if HOA approval or a permit is in play. Call (844) 560-0925 for a scheduling quote.
Often yes, depending on the height, location, and whether you’re on a corner lot. Fences that exceed the height allowance or affect a sight triangle usually need review. We check the current standards against your lot and let you know what’s required before we quote. Call (844) 560-0925 and we’ll confirm what applies to your address.
You can absolutely do a partial run, and many Prosper homeowners start with the back line and a side gate and add later. Running one line only keeps the cost in the lower band. We can stake out just the segment you want. Call (844) 560-0925 to price a partial run.
Yes, if it’s built right. A swing gate on properly footed posts stays aligned; the ones that sag start with shallow concrete and move a few seasons in. Our workmanship is covered by the 730-Day Done Right Promise. Call (844) 560-0925 to discuss gate options before we quote.
Most residential jobs run $3,500 – $9,000, with the typical backyard around $4,200 – $6,500. The total depends on linear footage, gate count, mesh gauge, and site conditions. Call (844) 560-0925 for an exact quote, and a written line-item estimate is free.
Get a Free Chain Link Fence Estimate in Prosper
Start with a free on-site estimate for a chain link fence in Prosper: (844) 560-0925. We’ll walk your lot, confirm the property line and any HOA or permit requirements, talk through gauge, height, and gate choices, and hand you a written line-item price. If the project grows, we can walk Fence Installation in Prosper and our wider Fence Installation service around the whole lot. We cover the full Prosper area, and our technicians have up to 12 years of experience.
Written by the team at Groundwork Construction Co.












