







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Carrollton, TX: What It Takes and What It Costs
Most chain link fence jobs on a Carrollton lot run $3,500 to $9,000, and a straightforward residential run is often finished in one to two days. That range covers the post holes, the concrete, the framework and the mesh; what moves you up the scale is length, gate count and how much old fence has to come out first. Call (844) 560-0925 for a free on-site estimate and we’ll walk the line with you.

How a Chain Link Fence Goes In, Start to Finish

Chain link is one of the few fence systems where the order of operations really matters, because the concrete has to cure before anything gets tensioned. Here’s how a typical Carrollton job actually runs.
Day 1 morning: walk the line, confirm the layout
Before a shovel goes in the ground, we call Texas 811 to have utility lines marked, and we walk the property line with you. This is where you decide exactly where the fence sits relative to the property pins, where the gates land, and whether you want a drive gate sized for a trailer or just a walk gate. On acreage lots the layout conversation takes longer, because a fence that’s four feet off the line at the front is twenty feet off by the back corner.
Day 1 midday: demo and digging
Old fence comes out first, and the hauling is part of the job. Post holes get dug to depth and set in concrete. On Carrollton’s expansive clay this is the part that separates a fence that stays plumb from one that leans by year three: the holes need to go deep enough to get below the active soil zone. We set terminal posts in concrete and brace them properly rather than just dropping them in a hole and hoping.
Day 1 evening through Day 2 morning: cure time
Concrete needs to set before we hang anything off those posts. This is the one stage you can’t rush, and it’s why a job quoted as “one day” usually isn’t a good sign on anything with real length or gate weight. Overnight cure on a standard residential job, longer in cold weather.
Day 2: framework, mesh and gates
Top rail goes up, tension wire or bottom rail goes in depending on your spec, and the mesh gets stretched and tied off. Gates get hung and adjusted so they swing and latch cleanly. Stretching is where a cheap install shows: mesh that’s hand-pulled looks fine for a season and sags after.
Day 2 finish: walkthrough
You walk the whole run with us before we call it done. Gate operation, post plumb, tie wire count, and cleanup. Anything that isn’t right gets handled then, and the work is backed in writing by our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Chain Link Options Worth Choosing Between
The material choices on a chain link job are narrower than on wood or vinyl, but the decisions still change the price and the lifespan. Here’s what actually matters.
- Gauge of the mesh. Standard residential is 11.5-gauge; 9-gauge is heavier and costs more but resists dogs and kids leaning on it. On a property with working animals or a shop yard, the heavier gauge earns its money.
- Coating. Galvanized is the baseline and the cheapest. Vinyl-coated (typically green or black) runs roughly 15 – 25% more per linear foot but looks better against landscaping and holds up well to North Texas sun. On a Carrollton ranch with mature trees and hedges, coated fence blends instead of shouting.
- Height. 4-foot is common for a marking boundary, 5-foot and 6-foot for containment. Taller means more mesh, heavier posts and more concrete, so the price climbs with every foot.
- Post and rail spec. Line posts, terminal posts and top rail all have gauge grades. This is where cheap bids hide savings, and it’s the first thing to check when a quote comes in unusually low.
- Gates. Walk gates are simple. Drive gates sized for a truck and trailer need heavier frames and proper bracing, and they’re the single biggest line item beyond length.
- Tension wire vs. bottom rail. Tension wire is cheaper and fine for most yards; a bottom rail keeps the mesh from being pushed up and is worth it where dogs are involved.
What a Chain Link Fence Costs in Carrollton, TX
Expect $3,500 to $9,000 for a residential chain link fence in Carrollton. Low end is a modest perimeter with one walk gate on flat, clear ground. High end is a long run on an acreage lot with a drive gate and old fence to remove.
What moves the number:

- Linear footage. The primary driver. Price is largely per-foot, so a bigger yard costs more even when nothing else changes.
- Height and gauge. 6-foot 9-gauge is meaningfully more than 4-foot 11.5-gauge, both in material and in post spec.
- Gate count and gate size. A double drive gate can add a meaningful chunk on its own. Each gate needs heavier posts and framing.
- Demo and haul-off. Removing an existing fence, posts and concrete adds labor and dump fees. Concrete footings in clay come out hard.
- Terrain and access. Slopes, trees in the line, and tight side-yard access all slow the job. Carrollton’s alley-access restrictions in older neighborhoods affect where we can stage materials and how close equipment gets.
Your written estimate spells out footage, height, gauge, coating, gate sizes and demo. What it typically doesn’t include: sprinkler line relocation or landscape repair if we hit irrigation, which we flag during the walkthrough so there are no surprises. Pricing is upfront, and the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Carrollton Lots Specifically Do to This Job
Carrollton’s postwar building boom left behind large tracts of ranch homes on generous lots, and a lot of those properties are now getting their first real exterior work in decades. That history shows up in chain link jobs in specific ways. Plenty of older Carrollton yards still have a fence from a previous owner set inside the actual property line, or posts sitting right where a utility easement runs, and we have to sort that out before digging. The clay soil here swells and shrinks with the seasons, so shallow-set posts that were fine in a drier climate lean within a couple of years; we set deeper and brace terminals properly. Alley-access rules in the older neighborhoods around Downtown Carrollton and the streets off Josey Lane affect where a dumpster or material delivery can sit, which is part of why we scope access during the estimate, not the morning of the job. And on acreage lots out toward the edges of town, long runs and drive gates push toward the top of the price range.
Does a Chain Link Fence Need a Permit in Carrollton?
Carrollton requires a permit for most new fence construction, and it’s worth confirming the rules for your specific lot before we start. We handle the permit paperwork and coordinate the inspection as part of the job, so you aren’t the one chasing the city. Height limits and setback rules vary by lot and by whether the fence fronts a street or an alley, and the alley-access requirements in the older neighborhoods are stricter than what homeowners expect coming from a neighboring city. We sort all of it during the estimate. Call (844) 560-0925 to get the specifics for your address.
Serving Carrollton, TX – Our Local Coverage Area
We serve Carrollton and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions
A typical residential chain link fence takes one to two days from demo to walkthrough, with cure time in between. Longer runs on acreage, multiple gates, or heavy demo push it to two or three days. We give you a realistic window in the estimate and call you if anything shifts.
Most residential chain link jobs here run $3,500 to $9,000, depending on length, height, gauge, gate count and demo. A short perimeter with one walk gate sits near the bottom; a full acreage perimeter with a drive gate sits near the top. Call (844) 560-0925 for an exact quote, and estimates are free.
No, as long as the scope doesn’t change. Our pricing is upfront: the number in your written estimate is the number you pay. The only things that add cost are changes you request or conditions we couldn’t see at the walkthrough, like an unmarked sprinkler line, and we talk to you before doing anything that adds to the total.
Yes. We handle the permit application and coordinate the inspection with the city. You don’t chase paperwork or schedule inspections; we do. That’s part of what the written estimate covers.
Every fence we install is covered by our 730-Day Done Right Promise. If something isn’t right, we make it right. Ask for the written terms at the estimate so you know exactly what’s covered and for how long.
Often yes, and it’s a common request in Carrollton’s tighter subdivisions where yards share a boundary. We’ll look at the shared line during the estimate and tell you honestly whether tying in makes sense or whether a clean new run is better.
Get a Free Chain Link Fence Estimate in Carrollton

A free on-site estimate starts with a call to (844) 560-0925. We walk the property line with you, measure the run, talk through height, gauge, coating and gate sizes, and hand you a written line-item quote with the footage and specs spelled out. No pressure, no vague numbers. If the fence is part of a full Fence Installation in Carrollton project, we scope it together. Homeowners often pair a new fence with ADU Site Prep & Utilities in Carrollton or Door Installation in Carrollton once the yard is being reworked, and we can price those in the same visit. Learn more about our Fence Installation service or see the full Carrollton service area.
Written by the team at Groundwork Construction Co.












