







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Farmers Branch, TX: What It Costs and How Long It Takes
Asphalt driveways and resurfacing in Farmers Branch typically run $3,500 – $9,000 for a new asphalt driveway and $250 – $700 for sealing an existing one, with most residential jobs finished in one to three days depending on square footage and base condition. Resurfacing (an overlay on a sound base) sits at the lower end; full replacement with new base prep sits at the upper end. Call (844) 560-0925 for a free on-site estimate and a written line-item quote before any work is scheduled.

Key Takeaways
- New asphalt paving in Farmers Branch: $3,500 – $9,000
- Sealing an existing asphalt drive: $250 – $700
- Full driveway replacement: $5,000 – $14,000
- Most jobs: 1 – 3 days on site, then a 24 – 48 hour cure before you park on it
- Black-clay soil and 1950s – 70s infill lots are the two biggest cost drivers here
How We Build or Resurface an Asphalt Driveway in Farmers Branch, Step by Step

Asphalt work is mostly prep. The blacktop you see is the top inch or two of a job that lives or dies on what’s underneath it. Here’s the real sequence we run on a Farmers Branch driveway, and where you’ll be making decisions.
Day 1 morning: tear-out and subgrade inspection
On a full replacement, we remove the old surface and haul it out (typically a half-day for a standard two-car drive). Then the subgrade gets inspected and graded for slope and drainage. This is where black-clay soil earns its reputation: if the base is pumping or cracked from wet-dry movement, we over-excavate and bring in select fill before anything else goes down. Skipping this step is why cheap driveways fail in two winters. You’ll decide here whether we’re doing a full replacement or a resurfacing overlay based on what the base tells us.
Day 1 afternoon: base prep and compaction
We lay a compacted crushed-stone base (usually 4 – 6 inches for a residential drive, more if the subgrade is soft from clay movement or drainage problems) and compact it in lifts. Duration runs two to four hours on a typical Farmers Branch lot. The homeowner decision at this stage is edge restraint: whether the drive is held by a concrete curb, steel edging, or a flush-to-lawn finish. Each looks and holds up differently, and it changes the price.
Day 2: asphalt placement
Hot-mix asphalt goes down at 2 to 3 inches compacted for a residential drive, rolled and finished while it’s still hot. Placement on a normal drive takes three to five hours, plus the tack coat and joints if we’re tying into an existing apron or garage slab. You’ll choose the mix grade here (more on that below) and confirm the final slope away from the garage. Water must run away from the house, not toward it.
Day 2 to Day 3: curing and striping
Asphalt cures fast enough to walk on within hours and drive on in 24 – 48 hours in North Texas heat, though a full cure to maximum hardness takes weeks. If you want a parking layout, edge stripe, or a turnaround at the back of the lot for a detached shop, that’s marked here. This is also the stage where we walk the job with you and note anything that needs a return visit before the 730-Day Done Right Promise clock on workmanship starts and stays running.
Sealing, if that’s the job
Resurfacing for a sound driveway means a seal coat, not a new surface. We clean, fill cracks, and apply sealant, all in a single visit of two to four hours. The homeowner decision is timing: seal too soon after a new pour and you trap oils; seal too late and cracks have already opened. If you’re not sure where your drive sits, we’ll tell you straight whether sealing will help or just postpone replacement.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make on This Job
Asphalt isn’t one product. Here’s what you’re picking between, with the honest trade-offs.
- Hot-mix vs. cold-patch. Hot-mix is the real thing, laid and compacted on site, and lasts decades with sealing. Cold-patch is a stopgap for a pothole on a rental property or a temporary fix. If a contractor offers only cold-patch on a full drive, walk away.
- Base thickness: 4″ vs. 6″. A standard car drive with good drainage does fine at 4 – 5 inches of compacted base. A drive that takes an RV, a heavy truck, or serves a detached workshop should go to 6 inches or more. The cost difference is real but so is the lifespan.
- Asphalt mix grade. Standard residential mixes are fine for most Farmers Branch homes. Hotter climates and heavier loads call for a slightly stiffer mix. We don’t push a premium grade where it doesn’t buy you anything.
- Edge restraint. Concrete curb, steel edge, or flush-to-lawn. Concrete holds up best on clay soil and costs the most. Steel is a mid-range option. Flush is cheapest but can erode at the edge on a slope-heavy lot.
- Seal coat, tinted or not. Standard black, or a charcoal/brown tint if you want the drive to match brick or a paver walkway. Tinted sealant lasts about the same; it’s a cosmetic call.
- Drainage: crown vs. swale vs. trench drain. On an infill lot where the drive slopes toward the garage, a crown or trench drain keeps water out of the slab. It’s the single most overlooked item in cheap bids.
For brands and finish options on the wider exterior scope, our driveway & pavers service covers what we pair with asphalt when a homeowner wants to tie the driveway into a walkway or apron.
What Asphalt Driveways & Resurfacing Costs in Farmers Branch, TX
Here’s the short version: $3,500 – $9,000 for new asphalt paving, $250 – $700 for sealing. Below is the line-item shape of a written estimate, and what pushes a job from the low end to the high end.

| Work | Typical range in Farmers Branch |
|---|---|
| Asphalt driveway paving (new) | $3,500 – $9,000 |
| Driveway sealing / resurfacing | $250 – $700 |
| Driveway replacement (full tear-out) | $5,000 – $14,000 |
What moves the price:
- Square footage. A single-car drive runs the low end; a long drive out to a detached shop runs the high end.
- Base condition. Black-clay subgrade that’s pumping or failing adds over-excavation and select fill, which can add $1,000 – $3,000.
- Access. Tight infill lots and alley access on 1950s – 70s streets add labor. Skid-steer access matters more here than on a new-build cul-de-sac.
- Edge restraint and drainage. Concrete curb plus a trench drain can add $500 – $1,500.
- Permit scope. A like-for-like replacement usually doesn’t trigger extra review; adding a new approach or changing the right-of-way often does.
What’s included in a written estimate: tear-out and haul-off, subgrade prep, base material, asphalt placement, compaction, edge restraint as specified, and cleanup. What usually isn’t unless it’s called out: drainage correction, tree root removal, driveway striping, and any work tied to a widened apron or a new approach to a detached shop.
See the difference
Before
After
Before
After
Before
AfterWhat Farmers Branch Homes Specifically Do to This Job
Farmers Branch is essentially built out, so driveway work here almost always means tearing out and rebuilding rather than pouring fresh on a new lot. Most of the drives we replace sit under post-war and mid-century single-family homes in ZIP 75234, where the original 1950s – 70s ranch was built with a narrow drive and a small apron. When a neighbor takes down an original ranch and squeezes a two-story infill onto the same lot, the drive on each side often has to be reworked too: tighter lot lines, alley access on the older streets, and tree protection for mature pecans and oaks that new-suburb builders never deal with. North Texas black-clay soil is the other constant. It swells and shrinks through wet-dry cycles, so we routinely run into drives that have heaved or cracked at the edge because the base was too thin or drainage was never corrected. Hail and high-wind events don’t damage asphalt much, but the grading and re-grading that follows a hailstorm rebuild often do. If the resurfacing is part of a full exterior rework, our Driveway & Pavers in Farmers Branch page covers the wider project scope, and our Farmers Branch service-area page shows what’s covered nearby.
Serving Farmers Branch, TX – Our Local Coverage Area
We serve Farmers Branch and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Asphalt Driveways & Resurfacing in Farmers Branch

A standard new asphalt drive in Farmers Branch takes one to two days on site plus a 24 – 48 hour wait before you park on it. Resurfacing or sealing a sound driveway is usually a single half-day visit. Full replacements with base correction can run to three days. Call (844) 560-0925 and we’ll give you a realistic schedule for your square footage.
A like-for-like replacement usually doesn’t trigger a separate permit; anything touching the right-of-way, the public approach, or a new apron generally does. The City of Farmers Branch runs its own permitting and inspection process, and we handle that as part of the job so nothing stalls on a technicality. Call (844) 560-0925 and we’ll tell you whether your specific job needs one.
Yes, if the base is sound and the failure is surface-level cracking or oxidation. If the base is pumping, heaved, or has failed from black-clay movement, an overlay just buys you a couple of years and hollows out underneath. The free estimate includes a walk of the base with you so you know which you’re getting. Call (844) 560-0925 to book it.
New asphalt paving runs $3,500 – $9,000, a full driveway replacement runs $5,000 – $14,000, and sealing an existing drive runs $250 – $700. Size, base condition, drainage corrections, and edge restraint are what push a job to either end. Call (844) 560-0925 for a written line-item quote – estimates are free.
Every asphalt driveway we install or resurface is covered by our 730-Day Done Right Promise: if the workmanship isn’t right, we make it right. That’s not a fine-print warranty that excludes the base or the edge. Calls are answered by a live person 24/7, so if something comes up after the crew pulls off, you’re talking to someone, not a voicemail box.
Get a Free Asphalt Driveway Estimate in Farmers Branch
If your drive is cracking at the edges, holding water, or you’re reworking the front of the lot after a rebuild, the fastest way to know what it actually costs is a free on-site estimate. We’ll walk the base with you, measure the square footage, and hand you a written line-item quote with the drainage and edge restraint spelled out. You’ll know exactly what you’re buying before you commit. Homeowners also often pair this with a Chain Link Fence in Farmers Branch to define a side yard or shop access, or with ADU Site Prep & Utilities in Farmers Branch when a new structure needs a driveway to reach it. Call (844) 560-0925 to schedule your free estimate.
Written by the team at Groundwork Construction Co.












